VTF1200 Series Open Chamber Single Zone Vertical Tube Furnaces

VTF1200 Series Split Open Chamber 1 Zone Vertical Tube Furnaces feature the famous Kanthal (Sweden) spiral wire coils embedded in Mitsubishi (Japan) high-quality grade 1500 alumina fiber insulation. A double-walled steel internal housing helps minimize heat loss to the exterior surface.

Furnace operation is controlled by Eurotherm (UK), allowing the user to connect to a PC for remote control and monitoring of the furnace. You can also save or export test results.

Features:

• Swing-open furnace chamber for fast and easy tube access
• Standard package includes set of stainless steel vacuum sealing flanges with valves and pressure meter
• Microprocessor-based self-tuning PID control provides optimum thermal process with minimal overshoot
• Multiple atmosphere processes in a single cycle are possible (ex: binder burn out in air and parts sintering under rough vacuum or inert gas environment)
• Built-in ammeter and dual voltmeters for easy monitoring and troubleshooting
• Built-in computer interface
• Long life type K thermocouple

VTF1200 Standard Package Includes:

• VTF1200 Vertical Tube Furnace
• 2 Quartz Tubes
• Stainless Steel Vacuum Sealing Flanges w/ Pressure Gauge
• Clamp, O-ring, and Valve (Pre-installed on Flange)
• 8 Pieces of Flange O-Rings
• Analog Flow Meter
• Stainless Steel Hook
• Quartz Thermal Block
• 1 Pair of Thermal Gloves
• 2 Spare Fuses
• USB/RS485 Computer Interface Kit
• Allen Keys
• 25A UL Fuse
• 4A UL Fuse
• Furnace and Eurotherm or Shimaden Controller Manual
• Eurotherm USB OR Shimaden CD for Software

Safety:

• Overheat protection shuts down the furnace if the temperature is outside of the acceptable range (refer to controller's manual) or when the thermocouple is broken or malfunctions
• Power failure protection resumes furnace operation right after the point of failure when power is reestablished
• Warning! NEVER fill the furnace with explosive gases, including Hydrogen, Carbon Monoxide, and Methane

Connection images above are for setup and are for reference only. Actual setup can be configured many different ways based on user preference. The bracket plate for the mass flow controller can be magnetically attached and detached from the surface for ease of use

Tubing sold seperately.